Rollease

Troubleshooting: Rollease Low-Voltage Motors

The motor is not responding. Make sure the motor has power.Make sure the controller has a good battery and is installed correctly.Adjust the antenna on the motor.Make sure the distance from the remote to the shade is in range.Check the wiring.Reset and reprogram the...

Rollease Low-Voltage Motor Programming Guide

Note: These instructions start as if the shade has never been programmed. If the shade has been previously programmed or needs to go back to factory default (So you can start from the beginning), please follow the “Resetting to factory default” directions before...

Troubleshooting: Rollease Li-On Motors

The motor is not responding. Make sure the motor is charged up.Make sure the controller has a good battery and is installed correctly.Adjust the antenna on the motor.Make sure the distance from the remote to the shade is in range.Reset and reprogram the shade. The...

Rollease Li-On Motor Programming Guide

Note: These instructions start as if the shade has never been programmed. If the shade has been previously programmed or needs to go back to factory default (So you can start from the beginning), please follow the “Resetting to factory default” directions before...

Troubleshooting: Rollease AC Motors

The motor is not responding. Make sure the motor has power.Make sure the controller has a good battery and is installed correctly.Adjust the antenna on the motor.Make sure the distance from the remote to the shade is in range.Check the wiring.Reset and reprogram the...

Rollease AC Motors Programming Guide

Note: These instructions start as if the shade has never been programmed. If the shade has been previously programmed or needs to go back to factory default (So you can start from the beginning), please follow the “Resetting to factory default” directions before...

What is channel zero for?

Note: This pertains to Rollease Acmeda Motors only. All motors that are programmed to the same remote, automatically respond to channel zero. For example, on channel zero, pressing the up button will move all blinds programmed to that remote up.